|Aug 01, 2013, 07:32 AM|
USA, ME, Ellsworth
Joined May 2008
I'll bet it does. Is the back plate and bearing tube composite too? Or does that transition to metal in there somewhere?
It think it was E-Flite that had or maybe even still have a motor with a plastic base that didn't do well in service. It was on the first generation foam glide that became so popular, really a good plane, but the motor base (it had threaded insert molded in for mouning) would develop cracks over time, probably from the heat.
Those aluminum bearing tubes and backplates are the primary route for gettng heat out of the windings. I always touch that base of the motor first to check for heat.
|Aug 05, 2013, 05:27 AM|
I usually cut off the backplate, or what I called the guard earlier, for ease of winding. This stator was obviously wound before being pressed into the composite.
|Sep 28, 2013, 08:44 PM|
I install 2 or ring of 17.8mm diameter x 2.5mm
But better best one 17.8-18 x 3mm.
In EDF with 28mm duct.
In one EDF of 30.5 as XRP 14B is best a thicker ring.
11 turn with 20AWG is easy.
But you can use 21AWG.
This motor is for Wemo mini fan 68mm. to 4-5slipo.
I'm about to RECEIVE one 70mm EDF 10 blades and a 14.
As can'll post the results with the new engine rewind.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||$200.00 Quick Sale CC 125 esc CC bec hoffman wild beast Het 6404 edf fan||mechengineer03||Aircraft - Electric - Power Systems (FS/W)||0||Jan 24, 2013 09:00 PM|
|Sold||Hoffman Beast and Wild Beast EDF motors||MNMadman||Aircraft - Electric - Jets (FS/W)||6||Nov 23, 2010 02:22 PM|
|Sold||Hoffman Beast & Wild Beast||hole digger||Aircraft - Electric - Jets (FS/W)||4||Mar 18, 2010 10:17 PM|
|Discussion||Twister W/ Hoffman EDF-70 (Beast) motor video||MikeMayberry||Foamy EDFs||10||Dec 04, 2008 10:27 PM|
|Sold||Hoffman magnetics Beast 70mm EDF motor and Pentium 80 ESC||The Don||Aircraft - Electric - Jets (FS/W)||2||Nov 15, 2008 06:09 PM|