|Jun 27, 2007, 05:26 PM|
Walsall, West midlands, UK
Joined Feb 2003
I have just aboout finished my model which is covered with film (like monokote).
However, It has fingerprints, some bits of epoxy and some CA dabs.
Yes I am a messy builder (out of practice and a very small workshop)
What can I use to clean the film and remove the epoxy and CA.
Please bear in mind that I am in the UK.
Any help welcome.
|Jun 27, 2007, 05:41 PM|
for finger prints any glass cleaner will work for the epoxy and ca posibly some asatone. you may be able to flake off the glue it just takes work or if it is a big area you may have to remove the film and put a patch on. hope this helps