|Feb 26, 2012, 10:51 PM|
1/4 Scale Airplane motor suggestions needed
I was hoping someone with hands on experience with large out runner motors can suggest which motor I can use on my new 1/4-Scale WWII Kayaba Auto Gyro. I have a build thread here on RC Groups in case youíre interested in seeing what Iím up to.
About five years ago I purchased this 63mm out runner motor from Hobby King seen in the first photo. I canít remember any of the specs on it but I think it was rated for a 6 or 7 cell LiPo pack but I canít be sure. Even though I designed the model around it I donít wish to use it any more since if something happens to it I will have a hard time finding the exact replacement. I also donít like the fact that the prop shaft is 12mm in diameter. I would prefer a 10mm shaft.
So what I am looking for is a 53mm to 63mm out runner motor that mounts from the rear and has a 10mm prop shaft. The aircraft is going to weigh around 15 pounds and maybe fly at around 45 mph top speed. I would like it to run on a single 6 or 7 cell battery and swing a 22Ē to 24Ē low pitch prop. I have a 90Amp 10 cell ESC so it would be nice to pull less then this amount when wide open. Just think of a big Piper Cub type of plane with lots of drag flying around, no 3D flying, heck I wonít even be a be able to do a loop or roll but it will have an almost ten foot 3-bladed rotor spinning away providing lift, which in itself is going to be cool to see.
I donít want to spend more then a hundred bucks and it would be nice if I can purchase it here in the US but I can go over seas if necessary. The wood mount shown in the photo is just tapped in place so I will design a new one for the new motor.
So if you have personal experience with a motor that you have used and you think it falls into what I need please let me know since I need to purchase a new motor ASAP.
|Feb 27, 2012, 08:00 AM|
This one might be made to work. I have a very similar one in an 18 lb Christen Eagle that works very well. This is also available in the US warehouse.
|Feb 27, 2012, 09:09 AM|
Check the shaft maybe, but check first the prop adapter diameter if you use the end bell prop adapter.
Dualsky XM6360DA + mount is presenting a true 8mm shaft for prop
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Motor suggestions for 1/4 scale Andreason||Flyer103||Giant Electric Planes||4||Sep 23, 2011 10:36 PM|
|Discussion||1/4 scale ASK 14 motor glider - motor help||marcv||Scale Sailplanes||3||Apr 05, 2011 10:33 AM|
|Help!||1/3 scale 100cc Towplane battery suggestions needed...||aero104||Scale Sailplanes||3||Sep 17, 2009 03:52 PM|
|For Sale||KANGE 1/4 SCALE R/C MONOCOUPE AIRPLANE, MOTOR & SERVOS||trashbug||Aircraft - Fuel - Airplanes (FS/W)||0||Jun 11, 2007 06:53 AM|
|Suggestions for a motor, controller, and batteries needed for a scale project||Eco8gator||Sport Planes||3||Jun 22, 2003 01:52 PM|