|May 09, 2012, 08:29 PM|
Joined May 2012
Frsky help on Airtronics V600
Hi, I just picked up an old manual trim Airtronics V600 to install the Frsky module on.
I am not sure how to locate the PPM, positive or negative locations on my board. Was wondering if there is a method I could follow to accomplish this as I havent seen it installed in my radio before only the v6000 which still has a different board.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||[GUIDE] frsky diy on flysky ct6b (hk t6a)||mick3485||Radios||4||Mar 04, 2014 02:46 PM|
|Discussion||Install FrSky V8HT on JR XP6102||jwlyons1||Radios||1||Apr 19, 2012 04:17 PM|
|Question||FrSky DHT-U pins (on white mini-jst connector)||Bertuele||DIY Electronics||4||Apr 01, 2012 01:37 PM|
|Discussion||FrSky voltage sensor on different receiver||M4d_D||Radios||1||Mar 15, 2012 01:27 AM|
|Hitec Feather - $30 - Airtron/JR 'positive' shift||Bill Germanson||Aircraft - Electric - Airplanes (FS/W)||6||Mar 17, 2003 09:28 AM|