|Oct 27, 2012, 08:28 AM|
Devo 8s question
Hi guys, sorry.... dumb question.
What does "All servos hold" mean in Walkera speak?
I'm assuming that it just freezes the servos while you are adjusting things like pitch and throttle curves... It's not a perminate selection, or tied to the switch postion right?
|Oct 27, 2012, 09:52 AM|
Hold just means that in case of signal loss the receiver continues to send the same information to the servos, so they keep their positions until the signal is restored (by which time the model may have crashed). For most purposes, the only important failsafe setting is that throttle go to zero.
Throttle hold is an entirely different thing. It means you can flip a switch on the transmitter and force the throttle (on a heli) to a preset position (idle).
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||DEVO 8S and Walkera V200D03 3D questions||andione1983||3D Electric Heli Flying||9||Jun 03, 2014 07:37 AM|
|Discussion||Devo 12s more responsive then Devo 8s||denodan||Multirotor Talk||0||Sep 09, 2012 03:55 AM|
|Wanted||devo 8 or devo 8s||DaddyDan||Aircraft - General - Radio Equipment (FS/W)||0||Jul 22, 2012 10:21 AM|
|Sold||Sold! Walkera V120D02s rtf with slipper clutch and devo 8s, 8 lipos, $230 obo shipped||ForceFedDSM||Aircraft - Electric - Helis (FS/W)||1||Jul 05, 2012 08:53 PM|
|Discussion||Devo 8s upgrade||maalse||Micro Helis||2||Jun 21, 2012 06:56 PM|