|Aug 23, 2012, 09:43 AM|
CRIUS AIO board query
Hi, sorry if this is a silly question, I'm a noob at this. I've been trawling through threads but can't find an answer.
I have just brought a CRIUS AIO board and am going through the process of configuring it. Unfortunately the USB socket doesn't seem to have been very well attached and has broken off. I've raised a query with the company I brought it from but they are being quite slow in responding...
I have a small FTDI conversion boad and wonder if its possible to connect this to any other part o fthe board to egain access to configure it etc. There are a number of ports around the edge, I'm just not sure which or if I can use one to gain access?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Crius MultiWii AIO boards||Katch||Multirotor Electronics||4194||Jun 27, 2014 04:24 AM|
|Discussion||APM2.5 vs CRIUS aio pro||little nellie||Multirotor Talk||43||Dec 12, 2012 11:39 AM|
|Help!||Crius MW AIO Pro Tx, Rx flash but no up-dates||Flying Canuck||Multirotor Electronics||3||Aug 23, 2012 04:38 PM|
|Question||CRIUS AIO v1 config||Crumpled||Multirotor Talk||1||Aug 18, 2012 04:37 AM|
|Question||Crius MultiWii AIO Vs. Naze32||vineet_p||Multirotor Electronics||5||Aug 08, 2012 07:40 AM|