|May 10, 2014, 08:07 AM|
Joined Mar 2009
So I decided that I should build a boiler for my D10....
Getting material was difficult, however I had some luck with local plumbing supplies shop, they had a piece of 4 inch tube and I got it free of charge.
2 inch 16 gauge was totally different story, I ended up buying it from Maccsteam.
Sounds a bit ridiculous but it is true, had to buy a piece of copper tube from half a planet away.
I do not have drawings for this boiler, I'm basically "freestyling"
Forming the endcaps was straight forward, two timber blocks, oxy set and a lot of patience, just keep annealing the part as soon as it starts ringing when you hit it with a hammer.
Anyway, have look at the photos, any advice is welcome
ImagesView all Images in thread
|May 12, 2014, 06:30 PM|
I can find my way around workshop easily , but I also believe that all people know everything, single person does not.
Is there any rule for smokestack size ? I intend to use 32 mm dia. tube.
Entire boiler will be 290mm long, am I overdoing things here ?
|May 14, 2014, 09:26 AM|
Most of the boilers I have seen have a flue that is smaller than the fire tube , I would guess by about a third. Not sure why , but I am guessing it is an attempt to get all that nice heat to stay in a little longer.
Don't forget to use higher melting point rods for the burner tube and slightly lower for the ends, like I didn't first time round and had silver solder melting all over the place
Nice engine by the way.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Yet another GhostQuad Thread||Mochaboy||Multirotor Talk||0||Nov 08, 2012 10:17 AM|
|Discussion||Yet another "what is it" thread...||bassfisha||Fuel Plane Talk||2||Oct 22, 2012 09:26 AM|
|Question||Yet Another "What do I buy" thread||AbeFM||Micro Helis||19||Jul 31, 2012 08:27 AM|
|Help!||Yet another NAZA arming thread||ivers||Multirotor Talk||20||Jul 14, 2012 11:46 AM|