|Sep 02, 2012, 08:34 PM|
Joined Mar 2012
cutting props down for pusher slot jets
Built a 26 inch ws slot pusher. Flew it with a 7x3.5 GWS. Flew ok but a bit slow. Took a master airscrew 8x4 and cut it down to a 7X4. Plane flew noticibly better but the motor was hot (not warm) afterwards and I only did 2 short full throttle runs. Should I cut it down another 1/2 inch to help the motor survive? Will that make enough of a difference in engine logevity?
thanks in advance.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Slot jet pusher, shortening props||jim2wright||Electric Plane Talk||3||Sep 02, 2012 11:26 PM|
|Discussion||Slot-jet >> ducted prop conversion||georgy||Foamies (Scratchbuilt)||3||Aug 22, 2012 04:32 PM|
|Discussion||Skyangel / HK Nano jets Mig -29 converted to Pusher Prop||UNGN||Pusher Prop Jet Models||11||Jul 16, 2012 09:54 PM|
|Discussion||Pusher Prop Jet F-22 100mph quest||Ron_RC||Pusher Prop Jet Models||12||Jul 08, 2012 12:42 PM|
|Question||1st Prop-in-Slot Jet||georgy||Pusher Prop Jet Models||13||Mar 13, 2012 09:38 PM|