|Jan 07, 2012, 12:07 PM|
Joined Apr 2008
Slowing Down Electric Retracts
I am having trouble thinking this one through.
I am considering buying a plane that comes with flaps, servos, 2.4 receiver, and electric retracts already installed. Can I adjust the speed of the flaps and retracts with my Aurora 9 TX's delay feature?
Or would I have to change the installed RX to a Hitec Optima RX in order for the RX to comminicate correctly with my Aurora 9 TX?
OR will the delay feature not work at all with electric retracts?
I realize there are aftermarket sequencers available that would probably have a delay feature, but I was hoping to avoid any additional electronic pieces or weight.
Thanks for your help.
|Jan 07, 2012, 04:11 PM|
If these are electric retracts with the motors built in, then they cannot be slowed down, except by running on lower voltage. The ones I've seen run at a very scale speed.
Mechanical retracts operated by a servo are also normally not able to have the speed controlled from the radio. Spektrum does make a very high torque proportional retract servo that can be slowed from the radio.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Problem with P40- Engine slowing down at full throttle||thercguru||Power Systems||21||Sep 18, 2011 04:21 PM|
|Discussion||Slowing down retracts||victor hull||Flight Accessories||21||Sep 18, 2007 08:08 AM|
|Slowing down retract speed||JayParke||Electric Plane Talk||8||Apr 19, 2002 08:18 PM|