|Mar 08, 2013, 05:33 PM|
Joined Feb 2012
Eagle Eyes FPV station problems!?
Hi, so I have the eagle eyes diversity receiver, and the osd pro. I have had 3 issues with it and was wondering if you can help me.
1. My tilt on the station doesnt tilt at all when I am flying the plane BUT the pan works and correctly follows my plane. However, I have calibrated the eagle eyes properly and when I test it on my computer, it pans to the correct heading and also tilts to the highest and lowest angle I have calibrated it for. HOWEVER, when I go fly my my plane, thats when only the pan works and the tilt does nothing. For example when I do a high fly over of my setup, the station doesnt tilt up at all! help?
2. My eagle eyes periodically makes a series of beeps in pair of two beeps when I have programmed the eagle eyes to not beep for anything other than low voltage, but it beeps occasionally even on a full battery. For example, if I am flying my plane, it will randomly start that series of beeps (pairs of two). its annoying, and not sure what it means...?
3. Today, my video display on my goggles went black when I was flying the plane...and then come back just in time for me to turn the plane back around towards me to get back in visible sight and land it. It was really scary, and it was so scary because today was the first day that it happened (I have been flying with my new fpv setup for a couple of weeks now (nothing more than 1km yet)). Do you have any guesses why this might have happened? because like I said, I have been routinely flying around 1km (until I get my RTH working I stay close) and have clear video, but today it went black and stayed like that for like 20 seconds...
|Mar 09, 2013, 12:33 PM|
Hi, here are some thoughts:
1) There are a couple of things that might explain your tilt issue. When you fly overhead, does the pan stop also? If so, there is a setting that disables the tracker when the model is very close, to keep it from swinging around wildly. This is "Min Radius frm Home for Trak" in the EagleEyes OSD menu. If that's not set to zero, this feature is enabled.
Another possibility is some sort of a misconfiguration. A quick way to verify this would be to use the OSD's simulator. As you fly the model in the simulator (disconnect your motor! ) the tracker should follow the model in both pan and tilt axis.
Please post your OSD config file (.txt) here and I'll take a look and see if there's a misconfiguration. And/or, you may want to clear the calibration and recalibrate, to see if that resolves the issue.
Re the series of beeps, that may be caused by an issue that is addressed in our more recent firmware. The latest is located here.
Re the goggle shutoff, did you have a chance to check the EagleEyes LEDs, to see what they indicated, or did you hear a beep from the EE indicating it might be a mode switch? Is it possible there's a loose connection between your goggles and the tracker? What type of goggles do you have?
|Mar 10, 2013, 01:27 PM|
Joined Feb 2012
Thanks for the input! And I found out what the problems where! First I realized I hadnt updated my eagle eyes firmware since I last updated the OSD Pro firmware, so I fixed that. Second, I install the new data software, and that elminated the weird beeping I was telling you about.
Anyways, so I found out that my servo motor that tilts my fpv station has a audible buzz most of the time and that that is causing a lot of noise in my video. And so that noise is making it so that I lose telemetry and that it causes actual blacking out of my video. So I am am trying to figure out if there is anyway to eliminate the nosie produced by my tilt servo...because otherwise I need to buy a new servo with more torque.
Do you know of any ways to take out noise produced by a servo motor?
|Mar 11, 2013, 10:06 AM|
Joined Jan 2008
"Out of Range!
The value of "Min Radius frm Home for Trak" should be in the range of 5 to 255".
Has this feature been disable in this firmware version?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Eagle Eyes FPV Station with Radio Shack Plastic Case (((SOLD)))||bah7566||FPV Equipment (FS/W)||7||Mar 07, 2013 08:28 PM|
|Wanted||Eagle Eyes FPV Station||boehmr||FPV Equipment (FS/W)||1||Jan 10, 2013 01:48 AM|
|Discussion||Eagle Eyes FPV Station Rapid Diversity Switching Problems||glassdogangle||Eagle Tree Systems||7||Dec 14, 2012 05:58 AM|
|For Sale||Eagle Eyes FPV station and Eagle Eyes Antenna Tracker||techcapsule||FPV Equipment (FS/W)||8||Feb 27, 2012 02:36 PM|
|Sold||Eagle tree osd gps complete fpv system and eagle eyes ground station never flown!||djdaveq||FPV Equipment (FS/W)||4||Aug 06, 2011 08:40 PM|