|Nov 05, 2012, 08:22 PM|
parts for a small 3D plane
I've become bored of micros and now are into big planes. Parts came from an 18" scratchbuild 3D plane.
what you see is what you get for $20 shipped. Paypal preferred.
10 gram outrunner (prop saver and prop saver band included)
Turnigy 6amp ESC
2x 240mah zippy (these were single cells from HK made into 2S)
3x 4.3gram HK servos
4 carbon rods with horns
2x 7x3.5 GWS prop
this one did not come from the scratchbuild but, I had it laying around and decided to throw it in
2x 1.5 gram linear servos (I shorten the wires and somewhere along the line lost the plugs to them. You can get the plugs from HK)
All items are used, but in good working condition.
Lipos both have been in storage in the fridge at 3.8v/cell
|Nov 05, 2012, 08:36 PM|
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Anyone have a small 3D profile plane or micro parts to make one?||justinlee1||Atlanta Area RC||24||Nov 04, 2012 12:56 PM|
|Discussion||Any small 3D planes capable of being broken down into parts?||Dogzilla||3D Flying||1||Jun 06, 2008 01:31 PM|
|Looking for a small, balsa, 3D plane like the lil banchee...||papasmurf||3D Flying||8||Jun 12, 2005 08:12 PM|
|Small 3d Plane for 3/8" FanFold||enigmabomb||Foamies (Kits)||5||Jul 02, 2003 03:20 PM|
|Looking for plans for a small 3D plane||Erik Johansson||Parkflyers||2||Dec 08, 2002 07:03 PM|