|Sep 09, 2012, 04:52 PM|
United States, FL, Bradenton
Joined Jan 2012
PL6 charging without balance leads connected?
Do any of the modes allow you to charge without having any balance lead plugs connected?
I tried using a generic charge board to parallel charge 4 packs (without any balance taps connected to the PL6) in the Faster Charging mode" and it says "bad cell count node wiring" and says the same thing when I am in High Power mode? I remember reading about a balance dummie plug for certain Powerlab models to get around this but can't find it again and don't want to mess anything up Lol.
|Sep 09, 2012, 05:26 PM|
Joined Sep 2007
For LiPos there is the LiPo 1s/2s Small Non Balanced preset, but its limited to 2 amps. The "plug" was for the Cellpro10s and allowed you to charge using only the balance connector vs charge with only the charge leads.
|Sep 10, 2012, 06:07 AM|
Same question asked many different ways for years now.
Simple answer with Power Labs and most other balancing chargers both main leads and balancing lreads need to be connected and balancing leads have to be the correct sequence as brands use different wiring orders.
Power Labs have Non Balanced Presets which can be used for 1-2S LiPolys at lower power.
One should learn how LiPlys are wired,the Power Lab Manual has wiring drawings for 1- X S for both FMA and JST sequence. I suggest one study the drawings.
Recent thread here
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||How to charge only using balance leads on Accucell 6?||Koo||Batteries and Chargers||7||Aug 03, 2012 08:50 AM|
|Discussion||charging a 3s battery without balance||widget2k4||Batteries and Chargers||33||May 18, 2012 03:39 PM|
|Question||charge through balancer without main wires connected?||sandal||Batteries and Chargers||16||Jul 04, 2009 10:37 PM|
|Discussion||Charging packs without balance taps with balance charger?||jbarr2000||Batteries and Chargers||18||Oct 13, 2008 07:59 AM|
|Question||Lipo without balancing leads||acidla||Batteries and Chargers||21||Feb 05, 2007 12:50 PM|