 |
 |
 |
|
Dec 07, 2012, 04:05 PM
|
|
United States, CA, Torrance
Joined Apr 2006
1,185 Posts
|
RhinoCam
Well I've been using MasterCam for years, but I think it's junk for doing wing molds and the like. To many gauging issues.
My question is for those of you who are using Rhino Cam, what tool paths do you use to clean up Leading edges? I am getting paths that are 100% better than mastercam but stilll don't know all the ins and outs of Rhino Cam paths. |
 |
|
|
|
|
Dec 07, 2012, 10:00 PM
|
|
USA, OH, Worthington
Joined May 2002
5,848 Posts
|
Between two lines machining - available in RhinoCam Pro
Do an offset curve of your LE curve, then machine "between two curves" with a very small stopover. The paths will be parallel to the LE. |
 |
|
|
Dec 08, 2012, 02:17 AM
|
|
|
United States, CA, Torrance
Joined Apr 2006
1,185 Posts
|
Cool I'll give it a shot, I think I have Pro
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question anyone here use rhinocam? | hawaiianspork226 | CAD/CAM | 22 | Oct 30, 2010 09:58 AM |
|
|