Hello,

Please find attached below a short INBOX of:
P-47 Thunderbolt from Nine Eagles

In case of any questions, just ask

INBOX - P47 Nine Eagles - micro plane RC (0 min 56 sec)

I have one of these with guts from a parkzone um p-51 in it. It is an awsome flier. One of my favorites.

Where can you purchase these in the States???...Looks very good but I would have to get rid of that spinner and put the smaller scale spinner in its place....That's the only flaw that I can find for this plane given its scale and probable low price...

Kevin

Hobbyking has planes and replacement parts. I bought the parts for my build.

Originally Posted by jwman

I have one of these with guts from a parkzone um p-51 in it. It is an awsome flier. One of my favorites.

My friend has P-51 from Parkozone. I have flight both. In my opinion, the Parkzone one is a bit better. The differecne is not maybe important, but is.

I will say in this way:
- if both planes would cost the same I would choose the Parkzone
- if the Parkzone is above 15% more expensive I choose Nine eagles

Originally Posted by Kevin Greene

Where can you purchase these in the States???...Looks very good but I would have to get rid of that spinner and put the smaller scale spinner in its place....That's the only flaw that I can find for this plane given its scale and probable low price...
Kevin

I am not sure of my english. Spinner... do you mean the propeller?
I think, the propeller mount it the best possible solution in this plane. Much better then in Parkozone.
It is not possible to damage the proppeler. even during a liitle hit, it comes away (but never during the flight).

Originally Posted by jwman

Hobbyking has planes and replacement parts. I bought the parts for my build.

Yes. I have also use the lipo 1S 160 nanotech to this plane.
The planes are very similiar - the electrity part are nearly the same.

Originally Posted by Kevin Greene

Where can you purchase these in the States???...Looks very good but I would have to get rid of that spinner and put the smaller scale spinner in its place....That's the only flaw that I can find for this plane given its scale and probable low price...

Kevin

If you want to do a Spektrum AR6400 brick and servo, gearbox and motor swap out from the Parkzone micro P51 or Sukhoi just get the Nine eagles p-47 parts from HK over here
http://www.hobbyking.com/hobbyking/s...F-80276272541E

Its a very easy job to instal the AR6400 brick and servo, gearbox and motor into the body parts . Dont forget to get the push rods makes it much easier to do the coversion.

I'm going to put one of these together with a $20 Target Hobby AR6400.

I just wish someone had the Chicken Decal. I planned to turn mine into "Norma" which is in the New England Air museum.

It's in the same fighter squadron as #40, but was #54.

Do you think that Beast Guts would work well in this P47? or would it be overkill?

Originally Posted by lord chris

Do you think that Beast Guts would work well in this P47? or would it be overkill?

I think it would work and be spectacular in the wind... especially beast 3D guts... but the foam is pretty light duty and the wing loading, pretty high...

I may give this a go just for a laugh.