|Jan 05, 2003, 04:46 PM|
Joined Jan 2003
Taping a plane - design question
I'm getting ready to cover my first plane, a Windrider Bee. I have a question about putting on the colored tape. I'd like to put some kind of design or pattern on the bottom of the wing, perhaps chevrons. Is it ok to just cover the plane with a sloid color, then use cut out pieces of tape to create a design? I would do the same on the left & right side of the bottom so the weight would be even. Or, when using tape, do you need to work the design in as you are taping. It seems to me that the colored tape should be complete pieces from the center of the plane to the wingtips for added strength & durability. But maybe not....?
|Jan 06, 2003, 01:45 AM|
Yes, make the first color out of long continuous pieces, then add trim color.
I would also heat shrink the first covering layer before adding the trim color - heat shrinking adds strength and rigidity, just be careful and keep the heat gun moving!
Many people do not know that you can heat shrink covering tape, but it works nicely!
Keep in mind that when using this tape it is thin and slightly transparent - if you put light colors over light colors they may not show up as you like...
Go here for photos - most of these were heat shrunk:
|Jan 06, 2003, 02:03 PM|
I would use a lighter color for the base and a darker color for the design. Dark colors bleed through the lighter shades and looks horrible.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Float design question for 18lb plane||Larry3215||Waterplanes||8||Jun 09, 2006 08:18 PM|
|Elexaco plane design requirements||RFD||Electric Plane Talk||15||Jan 14, 2006 01:01 AM|
|design question for you jet gurus||KSU Flyer||Electric Ducted Fan Jet Talk||10||Aug 22, 2002 01:19 PM|
|Elevon Design question||rparigoris||Power Systems||2||Feb 20, 2002 01:31 AM|
|another intake design question||Jensst||Electric Ducted Fan Jet Talk||15||Oct 18, 2001 10:20 AM|