thanks! i replaced the motor arm and just put the wires, thru the 3 pin and pulled them too the sides it worked but probably not for long! now i think imma have 2 replace another arm and motor! think i might just get a new one!

Originally Posted by Stenkryparen

Mounted the old board from my worn out V929 (rev:01 2012/06/23) in the X200 frame.

Motor connection
Red wire from X200 motor arm connected to plus side on V929 socket.

Green wire from X200 motor arm connected to minus side on V929 socket.

LED connection
All four black wires from X200 motor arms connected to one 470ohm resistor (0,25W), other end of resistor soldered to minus on the V929 board.

The mod is done in 1/2 hour.

The X200 is after mod a great flyer, and will fulfill the task to be a stable carrier for a key chain camera.
(Transmitter used is VL toys "RTF E728" ) at 40% rate it is tame.

Weight with LiPo excluded is 69,4 gram.

Here is pictures that show my modification.

do you still fly it in this configuration? still liking it?

did the mounting holes of the v929 pcb fit the frame/battery holder of the mjx200 exactly?

the new v959 rx PCB could also be of interest to mod the frame of the mjx200.

Yes the modified X200 is still alive, but I mostly fly this Quad (Crab 20).

Next plan for the X200 is to fit KK2, 4 ampere ESC and micro brush-less motors.
The frame is light weight and rigid, so this could be a agile quad.

Any body know where I might be able to buy the 12T Plastic Pinion Gears for the MJX x200.

Hello everybody, I have a question. Did anyone try to replace the remote controler with some proffesional like Futaba or JR? Any info is welcomed...

deleted

When I first got my x200, I disliked the programming, flight characteristics and transmitter.

A v959 pcb transplant took care of all issues for me:

regards . . . g
.

Video Slide Show:
.

x200mod (3 min 8 sec)

did someone compare x200 with 998? seem to have the same motor holders. does 998 have booms the same like wl toys(carbon) or like x200(aluminum)? which one is heavier?
Or are they just the same quad?
There seem to be 2 cameras: c4003(mjx x200) and NO.V001(998) or are they again the same camera?