|Apr 17, 2005, 07:30 PM|
Joined Apr 2005
Lipo parallel use and charging... A little help please
I just want to make sure I'm doing this right.
I have 4 packs, 2x - 3s2p, 1x - 3s3p, and 1x - 3s1p. I want 3s4p so I connected the 3s2p's together and the 3s3s with the 3s1p.
Thats good right?
All cells were balanced before I connected them in parallel.
Now I was also wondering about charging them, I would like to charge them together, both 3s4p packs, at once on the same charger...
Can I charge them together, even if say 1 pack has like .3v higher? Would they both balance out as they approach 12.6v???
P.S. All cells are the same (380mah 20C cells)...
|Apr 17, 2005, 11:53 PM|
As soon as you hook them in //, even w/o charging them, voltage will balance between the 2 packs (not specifically between each cell).
You can charge your packs hooked in // together.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Attention fellow modelers...a little help please...||Michael Bogh||Electric Plane Talk||20||Sep 10, 2002 07:43 AM|
|A Little Help, Please?||Ben Dere||Electric Plane Talk||0||Aug 22, 2002 07:23 PM|
|Attention fellow modelers...a little help please...||Michael Bogh||Life, The Universe, and Politics||1||Jul 17, 2002 07:58 PM|
|Attention fellow modelers...a little help please...||Michael Bogh||Fuel Plane Talk||1||Jul 17, 2002 07:58 PM|
|a little help please||drummermike85||Beginner Training Area (Aircraft-Electric)||9||Jun 15, 2002 11:37 AM|