|Aug 07, 2007, 06:22 PM|
Manual order suggestion
As far as I can see, Version 1.8 of the manual provides complete information about the system but I find that the flow of information tends to get one lost. For instance, One of the first things I want to do with the system is to bind the Tx and Rx, not read about the advanced features of the Tx module or have to dig out where the binding information is. So based on the 1.8 version of the manual, I would suggest that this would be a better flow:
Page 17 – Move the Set Failsafe Time Section in front of the Set Failsafe Map section
Page 18 – With the Set Failsafe Time Section moved as noted above.
Repeat Page 23 picture
Bottom of page 19 – Reset to Defaults
This keeps all the basic information at the front of the document where most users would expect it to be and then moves on to the more advanced features of the system. It will also keep all the Failsafe information in one continuous flow.
|Aug 07, 2007, 11:34 PM|
I second the flow chart idea. Once you have the basic concept, a single page "cheat sheet" would be very helpful. I spend most of the time it takes to program just flipping pages!
|Aug 08, 2007, 12:47 AM|
Joined Jun 2003
and add helicopter set up with pict in manual also
planes pic do not help helicopter on setup. put some pict on heli setup
show install in differ way in heli at would bee good
so ask at you thank on it jim
sec ask you go to Apollo Field Sepulveda Basin, CA,
do test asap to help all flying
and good luck. for i have your system work good so far