|Apr 05, 2013, 05:57 PM|
Not really a new idea, but an interesting concept, I was looking for an idea to build a very strong fuselage just 3 or 4 hours....
The general idea is to draw a foam fuselage of 50mm and cover with coro!
I made a very basic prototype to test the concept with the "Mochtang." For the 2nd model, I chose the Mig 3 and I try to forms "softer"
The photos may be clearer than my English ! or Chinglish !!
Preparation of the motor mount
Filter the rear part with a hot wire
The engine mount is bonded
Dress with coro
A soon to step 2
|Apr 06, 2013, 07:40 AM|
Cutting the coro
Collage with foam PU glue
Leave a wedge for the stab (ÚlÚvator)
Allow to dry until the next step ...
|Jun 24, 2013, 11:02 AM|
Oh that is very nice looking! I have a somewhat similar deign I am working on for a foamy, but haven't had any luck with getting the rounded wing tip right yet. I like your solution. Very nice styling on the paint job too.
|Jun 25, 2013, 01:47 PM|
Ah, that would explain why it is so consistent and smooth.
BTW, I couldn't tell from the pictures; how are you doing your wing attachment to the monoblock?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Hot to Bevel - Two Piece Foam Sandwich||SOOFLY||Foamies (Scratchbuilt)||3||Mar 20, 2013 10:24 PM|
|Discussion||Interesting Paper About Foam Sandwich Structures||Cap_n_Dave||Hand Launch||3||Jun 06, 2011 08:28 AM|
|Alert||Does anyone know which type of white foam Ceres use as the sandwich material?||cndstv||Composites Fabrication||3||Nov 20, 2009 10:28 PM|
|polyurethane foam carbon sandwich||GoatZilla||Composites Fabrication||5||Oct 14, 2005 07:37 PM|
|Foam and Balsa Sandwiches||nolasco||Scratchbuilt Indoor and Micro Models||12||Jun 23, 2002 05:53 AM|