|Jul 15, 2012, 10:43 AM|
Joined Jan 2004
FrSky wireless trainer system voltage
I'm hoping to set up a wireless trainer system like this:
The receiver attached to the teacher radio will be powered by the trainer port (square Futaba port). The problem is that my battery voltage can go up to about 11v after a charge, and the FrSky receivers can only take 10v
Does anyone know if this is ok, or will I need some kind of voltage regulator?
|Jul 15, 2012, 10:49 PM|
Joined May 2012
Because you just mean to build wireless trainer system, so I THINK it will be no problem for
D8R-XP to work with 11v (V8R7-SP Operating Voltage Range is 3.0V-16.0V).
We don't suggest Rx work with voltage higher than 10v because it's easily get servos brunt. Since you just use them for wireless trainer system, 11v should be ok.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Article||Futaba WTR-7 FASST Wireless Trainer System Review||Doctor Who||Beginner Training Area (Aircraft-Electric)||10||Jan 18, 2013 08:24 AM|
|Sold||Futaba WTR-7 FASST Wireless Trainer System||Caphead||Aircraft - General - Radio Equipment (FS/W)||2||Jul 15, 2012 12:52 PM|
|Sold||Futaba wtr-7 wireless trainer system||buck181||Aircraft - General - Radio Equipment (FS/W)||0||Nov 17, 2011 12:11 PM|
|Sold||Futaba Wireless Trainer System for sale.||Tyler318||Aircraft - General - Radio Equipment (FS/W)||1||Mar 29, 2011 07:32 PM|
|New Product||Futaba offers new wireless trainer system||RadiMani||Radios||6||Nov 18, 2009 06:29 AM|