|Jun 21, 2013, 02:35 PM|
Tulsa Jones, Oklahoma, United States
Joined May 2002
Have a PH80 hooked up to an Eflite power 32 with Zippy 40c 4000mah lipo.
When I throttle up, power comes up fine, but if I throttle back to idle and re-advance the throttle the motor barely ticks over. If I let the motor stop spinning completely and the prop stops, it will advance again with full power.
No bec in use.
The software is v4.05. Using auto calibration.
Can you give me any hints what's causing this.
I tried both of my PH80's and get same results.
|Jun 21, 2013, 04:22 PM|
Joined Feb 2001
Sounds like the new firmware is not 100% debugged. Try going back to the highest non-beta V3.xx firmware and see if that solves the problem.
Be sure and go to the download page and submit a bug report. That’s the way that CC knows they have a problem that they need to work on.
|Jun 25, 2013, 10:44 AM|
GO back to 4.02... there is a bug with 4.05 for some of the PH controllers. Like Mike said please fill out the bug report and return to 4.02... there will be a fix in the future. Thanks
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||PH80 overheating?||Atom1025||Castle Creations||0||Sep 24, 2007 07:48 PM|
|Sold||LR-1 Pylon Racer & 22-30-02/PH80/Etc.||Parallax||Aircraft - Electric - Airplanes (FS/W)||0||Nov 11, 2005 12:58 PM|
|Can't get PH80 and Hacker B40LMR to start||RicVaughn||Castle Creations||1||Jul 04, 2004 05:33 PM|
|Question||Battery to PH80 wire length?||MikeF||Castle Creations||2||May 14, 2004 10:57 AM|
|PH80 - won't restart when windmilling?||habazot||Castle Creations||2||Jan 07, 2004 01:14 PM|