 |
 |
|
 |
 |
Jun 28, 2012, 09:04 PM
|
|
Lucas, KS
Joined Apr 2003
2,004 Posts
|
X8 uav
I'm finishing up the X8 but i haven't found any cg info?? Whats a good place to set her at?? thanks
|
|
|
|
|
|
Jun 29, 2012, 12:26 AM
|
|
|
Dillingham, Alaska
Joined Jan 2010
1,514 Posts
|
The main X8 thread is down in the FPV forum here:
http://www.rcgroups.com/forums/showt...3&highlight=cg The consensus seems to be that the CG should be just aft of the finger holes but the debate is exactly how far. From .5mm to 5mm seems to be the range. *Disclaimer: I don't own one of these planes I'm just relaying information found in that thread. -Mike |
|
|
|
|
Jun 29, 2012, 09:31 AM
|
|
|
Near Austin
Joined Dec 2001
4,896 Posts
|
Did you do any sort of modifications to it from "out of the box"? Just started a thread and have several ideas that I think I'm going to incorporate in mine.
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion Navy UAV downed by Virus | small_rcer | UAV - Unmanned Aerial Vehicles | 3 | Jun 22, 2012 07:01 PM |
| Discussion Discuss the future of UAV (thesis) | fthrw8 | UAV - Unmanned Aerial Vehicles | 3 | Jun 21, 2012 11:40 AM |
| For Sale HoverFlyPro Control Board for Multirotor UAV's | Bruce Mandel | Aircraft - Electric - Miscellaneous (FS/W) | 1 | Jun 14, 2012 08:23 PM |
| Discussion Any info regarding this x8 setup?Better than coax x8? | sjak | Multirotor Talk | 11 | Aug 14, 2011 08:33 AM |
|
|