|Jun 08, 2003, 08:24 PM|
Brand-new Jeti ESC problem
I have a brushless Jeti 30-3P ESC that I put 3 flights on today for the first time. I'm running a Mega 16/15/5 with a 8 x 1650 AA NiMh Sanyo pack; Unicorn EPP wing.
I had a VERY minor nose-in on my third flight from about 10 feet up at slow speed. After this, the motor started acting very weird, sort of sputtering slowly when throttle is applied then cutting off almost immediately. It no longer beeps as it should when I plug the pack in.
What could I have possibly done to it? It was almost a complete non-crash and I don't see how I could have damaged the thing.
Any suggestions before I start ripping it out my new Unicorn?
Man, this hobby is a lot of work sometimes...
|Jun 08, 2003, 09:09 PM|
I would bet that you bent the shaft or caused some other damage to the motor and it it binding and drawing too much amperage.
Do you have another motor to check the esc on? I would check the motor very carefully. Even "minor" crashes (10 feet is pretty high) can cause significant damage.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||Brand New Jeti Jes 180 ESC||freddb3||Aircraft - Electric - Power Systems (FS/W)||0||Jan 17, 2007 11:52 AM|
|New Jeti esc's 040- $15, 180- $25, 350- $35||braxx||Aircraft - Electric - Airplanes (FS/W)||0||Jan 21, 2004 08:02 PM|
|Brand New Jeti 5 amp speed controller||thomer||Aircraft - Electric - Airplanes (FS/W)||2||Nov 27, 2003 01:32 AM|
|Brand new Jeti JES 60 esc||tripster||Aircraft - Electric - Airplanes (FS/W)||2||Apr 11, 2002 06:14 AM|
|BRAND NEW GWS ESC/NICAD PACK for TIGERMOTH, etc.||tigerstrike||Aircraft - Electric - Airplanes (FS/W)||1||Mar 09, 2002 09:33 PM|