SMALL - espritmodel.com SMALL - Telemetry SMALL - Radio
Reply
Thread Tools
Old Nov 25, 2014, 12:55 PM
Registered User
Joined Nov 2014
10 Posts
Discussion
Need some help connecting cc3d

I need some help conecting a frsky d4r-ii to a cd3d please help me
everywhere i look i cant get the right diagram
ROBBYDIZZLE is offline Find More Posts by ROBBYDIZZLE
Reply With Quote
Sign up now
to remove ads between posts
Old Nov 25, 2014, 12:57 PM
Registered User
United States, CA, Sacramento
Joined Sep 2011
153 Posts
Dont worry about the cable colors. The one with ground and positive goes to channel one and then follow the next cable and olacethat into the signal input of the rx and continue on. You are going to have excess cables because you have more cables than channels. The number represents the signal port on the DR4
dubels is offline Find More Posts by dubels
Reply With Quote
Old Nov 25, 2014, 02:04 PM
Registered User
Joined Nov 2014
10 Posts
Not sure if im talking about the right set up because from what i read a need to jump 3-4 and use 1 wire plus pos gnd
ROBBYDIZZLE is offline Find More Posts by ROBBYDIZZLE
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Need help connecting lightbridge TEAM.V.I.P FPV Equipment 2 Oct 19, 2014 12:33 PM
Discussion Building for the first time, need some help. Fenolftalein Scratchbuilt Multirotors 3 Oct 13, 2014 12:43 PM
Discussion ESC to Naza M Lite connection help needed Sammy3 Multirotor Electronics 4 Oct 08, 2014 06:19 AM
Question Need some help on Programs and code for a QTR Project. TarikAgcayazi VTOLs 6 Sep 28, 2014 12:32 PM
Question need help in connecting battery , ESC and motors . siddharthsingh Multirotor Electronics 0 Sep 28, 2014 07:47 AM