|
|
|||
|
|
Quad Wobble
Hello,
I have just built a new airframe and I want advice on sorting out a wobble on it. The air frame is: Arms and mounts from a Talon v2, http://tinyurl.com/cczcxpf Centre plates from a Talon Octo, http://tinyurl.com/c3p69vy Landing gear is http://tinyurl.com/cykzmug The electronics is: 4 x Multistar 30a Opto ESC's http://tinyurl.com/d2nj8wm 4 x Multistar 4822-690Kv http://tinyurl.com/bmlsse7 Power distribution board, Naza M/GPS, AR8000, DX8, 2 x 4s Nanotech 2650 batteries. Props are 12x6, reasonably balanced. I have set it up in the Naza config as a clean config in x config. I started with the gains all on 100% and have now moved them to: (Basic) Pitch, Roll, Yaw 150%, Vertical 100%. The Attitude Gains for Pitch and roll are both 150%. The video below shows the flight in Altitude mode rather than manual on the above mentioned gains, please can you give me some suggestions where to go from here as my previous quad was a Gaui 330xs and a Talon v2 and for both I never needed to change the Naza settings from the default.
Many thanks Duncan |
||
|
|
|
|
|||
|
|
this video shows perfectly the different affects of incorrect gain settings and how to tune them.
|
||
|
Latest blog entry: Graphite ecks
|
|||
|
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion Speed wobble? | ecks | Multirotor Talk | 7 | Jan 11, 2013 02:38 PM |
| Discussion V911 heavy wobble | Jonny_Z | Electric Heli Talk | 11 | Jan 11, 2013 12:49 PM |
| Help! My Mikrokopter quad is very unstable and wobble like creasy. | Itzik Ronen | Multirotor Talk | 2 | Mar 29, 2011 10:33 PM |
| Help! Gaui Quad Wobbles A little any advice? | djdaveq | Multirotor Talk | 3 | May 24, 2010 09:41 PM |