I have one of the new DS94 HST fans for sale. Comes from Schuebeler with motor installed. It is the most powerful 128mm fan/motor combo you can buy for a 12s set up. It is also rated to be run on as much as 14s if you need around 30lbs of thrust. You can buy one for $1210 plus shipping. Because the fan is not mass produced the lead time can be awhile. Mine took 3 months to arrive. I'm offering this one at $895 you pay what ever method of shipping you like. You can have it in a matter of days/whatever speed of shipping you pay for.

It is rated to just a touch under 24lbs of thrust on 12s at around 6500 watts. Best info available on Schuebeler's website. It is absolutely smooth from 0 to 100% throttle and very quiet due to the high blade count.

The fan has a total of 7 minutes of run time. The rotor blades were chipped but a brand new complete rotor has been received from Schuebeler and installed.

I have a pair of Castle Creations ICE HV160 V2 controllers also with 7 minutes of flight time each. Will sell at discount at $219/each or $199 with fan.

For photos and info look see here;
http://www.rcgroups.com/forums/showt...7#post23059898

Someone is going to get a great Christmas special on this fan/motor if the jet I have coming at the end of November does not have room for this fan. PM what you would like to pay. Highest bidder will likely get it the first week of December as my jet is due end of November and I believe it's for a smaller fan.

Carl,

Which motor does his have? I think in another thread you said it was a 700?
It looks like from the pictures that the plug in wire connectors are missing? Any reason for that.

I'm in the market for (2) DS-94-DIA HST with DSM6745-700

Terry

Has the high powered 700kv motor for maximizing 12s thru 14s. 24lbs thrust 12s and 30lbs thrust on 14s per factory. And quiet.

I requested and paid for an upgrade. Instead of having 6.5mm bullet connectors glued to the sides of the fan I requested they just run the wire leads out of the fan and leave about 10" long so I could run them to the ESC and either solder or use Castles 6mm connectors. I had one of the DS94 640kv fans for testing and noticed that the standard configuration with the bullet connectors hard mounted to the housing and directed outward from the housing (tangent?) it made it difficult to mount the fan in a jet as I had to use a male bullet to insert in the one glued to the side and this bullet then sticks out even further from the fan housing. They do not lay nice and neat next to the fan housing facing front to rear. They take up space where you will either be supporting your fan mounts or in my case where my landing gear was mounted as they stick out to the sides. By requesting the wires simply be extended out of the fan housing I was able to avoid all of this. The wires are visible in the photo as suppled by DS other than Castle bullets on the ends. I have 6mm Castle bullets on the fan and corresponding 6.5mm castle bullets on the ESCs that are also for sale. Do you need an ESC to go with it?

Hi

I will take one at 895.00 plus shipping. Please pm me with instructions.......

randy

PM sent

Wait a minute. I was first in line for two of them......

Terry

I sold one months ago. I only have one left. I've sent Randy paypal instructions as he indicated he was prepared to purchase. If he pays within 24 hours the fan is his. If not I will post here that the fan is available. That would be around 1:30pm tomorrow Eastern time.

Payment received, fan sold by itself.

Still have the two ESCs and can ship them today.