|Jun 05, 2013, 10:17 PM|
Joined Jun 2013
Help Needed MultiWii Pro Sketch Removal
This is a dumb question for which I apologize. I am trying to set up a Hexacopter that uses an Atmega 2560 control board. Using MultiWii Pro 2.0 (Arduino 1.0.2) I loaded firmware with the incorrect configuration. After doing this, I opened the board with MultiWii GUI in real-time and saw the incorrect configuration, but noted that the gyros all seemed to work when the board was moved around. I then went back to the sketch, and changed the configuration to the proper HEX6X. I then loaded this revised firmware on top of the incorrect version. Now the GUI display still shows the incorrect configuration and all the gyros don't show motion. Throughout all this the yellow and blue leds on the board are solid and the green and red lights are alternately blinking (I think this means the throttle is locked). Also when I use the Verify/Complie command in Arduino, I get an "Error Compiling" message.
Can someone tell me how to remove the incorrect sketch from the control board, or otherwise reset it so I can load the correct version of the sketch?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Need help on MultiWii Pro with GPS||tnt2k03||Multirotor Electronics||9||Jun 14, 2013 12:01 AM|
|Discussion||multiwii pro with gps - help loading a sketch||dubzn1||Multirotor Talk||13||Jun 08, 2013 08:45 AM|
|Discussion||Need help with multiwii pro||3dx450||Multirotor Electronics||2||Apr 10, 2013 11:09 PM|
|Discussion||need help with multiwii pro||3dx450||Multirotor Electronics||4||Apr 05, 2013 06:14 PM|
|Help!||cant upload sketch to crius multiwii se v0.2||ash123||Multirotor Electronics||2||Jan 16, 2013 09:25 PM|