HobbyKing.com New Products Flash Sale
Thread Tools
Old Sep 09, 2013, 07:01 AM
Registered User
Joined Sep 2013
6 Posts
Running in the engine OS MAX .21 TM. temperature

Engine OS MAX .21 TM
Driven around for instructions http://www.rcmotors.ru/pages/breakinengine/
Put telemetry: RPM, temperature

Has started is easy
Fuel Byron nitromethane 16%, 9% oil

Speed ​​from 10 000 to 13 000
I measure between the radiator and the block.
The temperature rises rapidly from 90 to 120 and beyond.
Very quickly comes to 130.140. I further off the beaten path and wait until cool down to 90 degrees and then start.

The carburetor is open to the factory settings. 3 turns.

Increased to 3.5 turns but the temperature fell.
Whether the situation is normal?

And I can not understand the words of the manual:
COMMENTS: Needle Settings:
- High Speed ​​Needle (Needle Valve) 2-1/2 turns out from close.
To break-in close approximately 30 after running one tank
of fuel through vehicle, repeat five times
- Mid Range Needle (Mixture Control Valve) Screw head is exactly
1/2 turn in from flush with the carb body
- Low Speed ​​Needle (Metering Needle) Turn 30 clockwise to lean
mixture or counter-clockwise to richen mixture

It turns out that the factory setting 2.5 turns. and the first 5 tanks have to close to 30 degrees each time? I mean, just on these sex trafficking? And the mixture is significantly poorer than 3 turns. And the engine will warm up even more.

What is normal for the number of turns of idling?
investigator is offline Find More Posts by investigator
Reply With Quote
Sign up now
to remove ads between posts
Old Sep 10, 2013, 03:25 AM
Registered User
Joined Sep 2013
6 Posts
Last night, on the advice of the above:
Unscrew the needle low speed until until it became deaf. 1.5 turns left
Turnover fell to 6-8 thousand
The temperature went to the Range 80-90
Oil tank with about nateklo 1 cube. This nabryzgalo, and then emerged from vyhlopushki. By the way about the nozzle. The collective farms of shrinking. Skills can temporarily because there is no way to come up with something else.

From the graph shows that 16% of fuel 100ml Byron developed a in 13.5 minutes
The temperature was 85-95 in the second half after enrichment baseman.

Results of the second tank
Open the gas valve chutchut that would not stalling and warming up. In the second half of the schedule after warming up a little damper closed. But the temperature still barely reached 90.
investigator is offline Find More Posts by investigator
Reply With Quote

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Running in the engine OS MAX .21 TM. temperature investigator Car Talk 0 Sep 09, 2013 02:25 AM