Originally Posted by scrape

I think I pushed the battery to far. Think I'll keep it closer to the ground @ the end of the pack.

It's official...you broke it!!!

scrape: bummer. I never let my lipos get to low. Good thing you had those led light strips to hold it all together!

Originally Posted by scrape

I think I pushed the battery to far. Think I'll keep it closer to the ground @ the end of the pack.
http://www.youtube.com/watch?v=2vi__gd84XI

Is That a sc2000 cam you are using if so how did you hook it up to the EZosd

Sorry about the crash

Originally Posted by Vantasstic

It's official...you broke it!!!

Originally Posted by glmccready

scrape: bummer. I never let my lipos get to low. Good thing you had those led light strips to hold it all together!

Originally Posted by tech69x

Is That a sc2000 cam you are using if so how did you hook it up to the EZosd

Sorry about the crash

No, it a RMRC-600 they have a cable for plug & play hook-up. Thanks

OK, I am going to move my Naza to this HT-FPV frame, have been using a CopterControl board. Question:

I'm using Turnigy Plush 30A esc, and currently I have only the signal wire (white) connected on 3 of 4 ports on the FC. All 3 wires (red, black and white) are connected on 1st port. Using the Naza FC do I need to reconnect all these wires again or does it matter, if all 3 wires are intact coming from the esc is that ok as well?

Just curious.

Originally Posted by shdwkeeper

OK, I am going to move my Naza to this HT-FPV frame, have been using a CopterControl board. Question:

I'm using Turnigy Plush 30A esc, and currently I have only the signal wire (white) connected on 3 of 4 ports on the FC. All 3 wires (red, black and white) are connected on 1st port. Using the Naza FC do I need to reconnect all these wires again or does it matter, if they are all 3 wires are intact coming from the esc is that ok as well?

Just curious.

Just one like the cc3d

Originally Posted by tech69x

Just one like the cc3d

If I have 4 brand new Turnigy 30a ESCs do I still need to remove the wires from them or can I leave them intact? I know with the DJI esc/motors you don't touch anything.

My bad you have to take all of the power wires off

I just looked at mine to be sure

Originally Posted by tech69x

I just looked at mine to be sure

you have a picture? So I only want the white wire connected on all the Plush 30A esc's to the naza then correct?

No the white and black

I use a Naza on mine and you only need to run the white signal wire...

Originally Posted by SDSURFnGLIDE

I use a Naza on mine and you only need to run the white signal wire...

Ok, I will remove all wires except the white one. You also have the Plush 30a esc as well right? I'm reading that some folks are having problems with this esc and they had to re-flash the firmware, hopefully i won't have to do that.

I have been using flashed esc's with no problem

You need to go here and ask

http://www.rcgroups.com/forums/showt...0#post23363800