HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Aug 13, 2012, 07:58 AM
Registered User
Joined Apr 2012
83 Posts
Discussion
Change pin used for motor in MultiWii code

Hello everyone. I have a promini 328P board. The promini is supposed to be able to control 6 motors, for a hexacopter.

I have recently managed to fry (it would seem) pin nr.3, so it can no longer control an esc.

Since I am trying to run a quad, I hope I correctly assume that I am left with two usable pins on the board, which could be used as a replacement for pin nr.3.

The only thread I found on this subject is this one http://www.multiwii.com/forum/viewtopic.php?f=8&t=1382

I tried the advice from that thread, but it did not work.

How can I change the code to use pin nr. 5 or 6 (or perhaps A1 or A2??) instead of pin 3?
Marvos is offline Find More Posts by Marvos
Reply With Quote
Sign up now
to remove ads between posts
Old Aug 21, 2012, 08:21 AM
Registered User
Joined Apr 2012
83 Posts
Found the solution: http://www.multiwii.com/forum/viewto...p=21416#p21216
Marvos is offline Find More Posts by Marvos
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Careful! Warning! rabbit Flight Controller uses stolen code from MultiWii hamburger Multirotor Electronics 1107 Sep 15, 2012 08:00 PM
Discussion Changing CAMSTAB pin out on MWC mega Foam boy Multirotor Electronics 0 Aug 07, 2012 12:54 AM
Discussion Two changes to the tax code that would significantly change politics ... logan5 Life, The Universe, and Politics 23 Apr 12, 2012 02:57 PM
Discussion Calibrating ESC's using multiwii code mstanescu Multirotor Talk 0 Mar 11, 2011 02:37 AM