|Mar 01, 2015, 12:47 PM|
Joined Mar 2015
KK board 5.5 V2.9
Guys this is my first time building a quadcopter.
i just finished with all assembly but when i move stick in left or right in my Fs ctb 2 adjacent rotors stops or slows down.
I am using KK board in + configuration but the box in which it came is labelled as "kkV5.5 xcopter v2.9" does that mean that the board is initally in X-configuraition and i have to set it to X configuration? Please Help...
|Mar 01, 2015, 03:21 PM|
The KK V5.5 XCopter V2.9 means the Board is Version 5.5 of the KK hardware that is running Xcopter firmware version 2.9. The Firmware sets the board up to work with an Xcopter frame.
You have to set the KK so the Arrow points in the direction of flight...
Scroll down to page 9...
And make sure your radio is setup in AIRPLANE MODE.
|Mar 01, 2015, 09:32 PM|
Just follow the board setup instructions...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Rave||HK KK V2 Quad board (and other recent KK boards)||randall1959||Multirotor Electronics||2584||Aug 11, 2014 03:01 PM|
|Sold||KK Blackboard V5.5 plus HK V2 Green Board and Flash tool||Bonestockz06||Aircraft - Electric - Multirotor (FS/W)||2||Mar 06, 2013 03:16 PM|
|Question||KK v5.5 Flight Circuit Control Board v2.9||Guntar||Multirotor Talk||0||Jan 07, 2013 09:36 AM|
|Found||WTB KK Controller V5.5 Board for HexCopter, V2.5||finover9||Aircraft - Electric - Multirotor (FS/W)||0||Apr 03, 2012 04:58 PM|
|Sold||KK 5.5 clone board, blowout!!! Have 20 boards that need to go!!!||tc3wins||Aircraft - Electric - Multirotor (FS/W)||20||Jan 27, 2012 03:38 PM|