HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Sep 29, 2013, 06:22 PM
Registered User
Joined May 2011
2 Posts
Hey I know it's not good but that can sometimes take a few days before I reply to mail.
Because I have a lot of work and FPVlongrange is a hobby and therefore it may take a few days between I read the mail.


Regards John
John Jensen is offline Find More Posts by John Jensen
Reply With Quote
Sign up now
to remove ads between posts
Old Nov 24, 2013, 01:08 PM
Enjoying life through flight
Joined Mar 2012
235 Posts
Hello,

I have recently purchased the UHF repeater system and it is not working with my EzUHF.

I have programmed the repeater to 8ch and I am using my Spektrum Radio/Receiver.

I know that all of the wiring is correct, but no matter what I do, my EzUHF will not correctly startup. When I power on the EzUHF, it just starts beeping, signaling that it is not receiving a good PPM signal from the repeater.

Here are more details of my setup:
There are four wires coming out of the ezuhf cable. I have connected the red one to the yellow signal wire on the repeater, and the white wire on the ezuhf cable to the black wire on the repeater system. I know that this is the correct assignment of cables as I have tested where each cable does goes with a multimeter. I have tried switched modes on the repeater to both 8ch and 9ch, but neither works.

I know that this whole problem is not because of the ezuhf because it works fine when it is connected directly to my Spektrum Dx18.

Any help would be appreciated.

Thanks

Best,
George
BigEast is offline Find More Posts by BigEast
Last edited by BigEast; Nov 24, 2013 at 01:15 PM.
Reply With Quote
Old Jan 01, 2014, 04:16 PM
Registered User
Joined May 2011
2 Posts
Hi Happy New Year to all
The problems with Ez is that they have changed little on how PPM stream should be.

I have changed a bit in the software and now it works with Ez again.

If anyone has one they would like to have obdateret please send an email and I will say what you need to do.

Regards John
John Jensen is offline Find More Posts by John Jensen
Reply With Quote
Old Jan 17, 2014, 02:04 PM
Registered User
crazytaz's Avatar
New Zealand, Bay Of Plenty, Tauranga
Joined Dec 2008
29 Posts
Why can you not just take the PPM output from your RX and connect it directly to the PPM in on the EzUhf Unit ... why the need for the converter ..is it just for people with out PPM capable Rx ?
crazytaz is offline Find More Posts by crazytaz
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Yippee! DRAGON LINK - New V2, Professional Grade Long Range FPV System, Always in Stock ! JettPilot FPV Equipment 28247 Today 09:47 AM
Question UHF System Can connect to the 7 Channels Radio System ? RanDavari FPV Talk 7 Nov 15, 2011 10:04 AM
Suggestion Flyinjrc74 repeatedly abusing the feedback system. flyer368 Site Suggestions / Complaints 1 Nov 11, 2011 01:22 PM
Discussion Alternative to expensive UHF system fpvguy FPV Talk 1 Sep 19, 2011 11:32 PM
Discussion How do I switch off 2.4 Ghz system when I only want to use UHF system? Voguna FPV Talk 1 Oct 07, 2010 06:16 AM