|Feb 09, 2012, 07:43 AM|
Hacker X-40-SB-Pro ESC
I have the Hacker X-40-Pro ESC and it comes with a round coil in the middle of the receiver wire with several wraps around it.
I've only seen this on the new Hacker ESC's and I assume it's there for noise supression of the ESC to the receiver.
I have an application where this coil is getting in the way of running the receiver wire and I'd like to remove it.
Would it be acceptable to remove this coil?
Thanks for your comments
|Feb 10, 2012, 08:04 AM|
Joined Jan 2010
Seems pretty hard to get answers around here sadly.
If it helps, I asked a similar question about a Kontronik Jive as they also ship with the ferrite core on the receiver wire.
The official answer was to leave it on the wire as even with 2.4GHz equipment it was needed to avoid potential problems.
Many people report removing them on various ESC without issues, but I can't see any manufacturer fitting them and then telling you it is OK to remove them.
|Feb 10, 2012, 10:56 AM|
My application is in a 48" foamy. I know its there for a reason and realize the standard answer is to leave it attached but I'm tempted to just remove it and see what happens.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||Hacker X-40-SB-Pro ESC||Patron||Power Systems||2||Feb 10, 2012 07:15 AM|
|For Sale||NIP Hacker X-40 SB Pro||livinma1||Aircraft - Electric - Power Systems (FS/W)||0||Jan 03, 2012 09:55 PM|
|Sold||Hacker X-40 SB Pro ESC/Bec 41.00 shipped||boatdoc||Aircraft - Electric - Power Systems (FS/W)||2||Oct 20, 2011 11:42 AM|
|Sold||NIP Hacker X-40 SB Pro ESC $65.00 Shipped Conus.||livinma1||Aircraft - Electric - Power Systems (FS/W)||2||Aug 08, 2011 12:14 PM|
|Sold||Hacker X-40 SB Pro ESC $40 shipped||The Don||Aircraft - Electric - Power Systems (FS/W)||1||Jun 25, 2009 08:13 AM|