|Mar 11, 2015, 02:47 PM|
Vector, X8(delta)-problem with YAW in the 2DH.
We bought three vectors in the RMRC. We put them on the plane Skywalker X8 (delta without Rudder).
Our X8 has drift of the course in the mode 2DH. Vector corrects rate is too slow (every 20 seconds), that leads to a zigzag trajectory.
We tried to change the sensitivity axis Yaw on the ground. When we turn the aircraft on the table around the axis Yaw, we do not observe visible reaction of elevons (as we can see it when we turn around the pitch and roll axis).
1. Will move elevons when changing Yaw axis mode 2DH on the table in the workroom (on the ground)?
2. Which sensor (compass or gyroscope or GPS) for correction the Yaw axis in the mode 2DH?
P.S. All procedures related to calibrate the compass, reset trim in the air, we were repeatedly.
Sorry for our English. Thanks.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Naza V2 YAW Problem/ YAW Wobble ?! (with video)||Steve2303||Multirotor Talk||1||Oct 04, 2014 10:20 AM|
|For Sale||VecJet PF delta with vectored thrust pusher motor||cedarville||Aircraft - Electric - Airplanes (FS/W)||4||Sep 12, 2014 07:07 AM|
|Discussion||Help with my A2 in my Hexa (Yaw Problem)||shawnadams||Multirotor Electronics||12||Mar 05, 2014 06:31 PM|
|Discussion||X8 yaw control with naza||alibizzle||Multirotor Talk||2||Aug 14, 2013 08:37 AM|
|Discussion||Yaw issue with 4.0 upgrade on x8 and Y6||tahoelight||Hoverfly Technologies||11||May 04, 2012 01:37 AM|