Thrust Tube Layout Calculator
Ok I just finished writing this one because I was sick and tired of waiting 1000+ seconds for the "cone" program to start up since I'm too cheap to pay for it.
Anyway this spreadsheet isn't as cool as the cone program, but it gives you the info you need to roll your own. All you need to input is the outside diameter of your fan, the diameter of your tailpipe, and the length of your tailpipe. NOTE: ALL DIMENSIONS SHOULD BE IN millimeters. The spreadsheet will work if you use inches or feet for that matter, but since most people use mm as the units of measure for EDF I figured I would stick with convention. But as long as all units are the same then the sheet works fine. Oh yeah, input in the blue fields in the upper left. Results are in the yellow fields.
Edit: I found an error in the formula. DOH Sorry about that to the 7 people that bothered to download the original spreadsheet. It's fixed now and has been verified.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Easy fsa and thrust tube calculator?||livnpaintball||Electric Ducted Fan Jet Talk||26||Jun 15, 2014 01:26 PM|
|Discussion||ESC in thrust tube mods||Boogie_||Electric Ducted Fan Jet Talk||1||Aug 16, 2011 05:06 PM|
|Idea||Found easy thrust tube for HET 6904||soundguy63||Electric Ducted Fan Jet Talk||2||Jul 31, 2011 03:16 PM|
|Help!||Thrust tube repair?||Kenta78||Foamy EDFs||2||Jun 05, 2011 07:56 AM|
|Discussion||Thrust Tube Layout for a L-39||jhamm||Foamy EDFs||7||Apr 19, 2009 07:57 PM|