|Feb 12, 2013, 01:13 AM|
Joined Dec 2012
Centering Servos using a digital pitch gauge.
I am a newbie. But I found a neat trick (at least I think so) for using my digital pitch gauge to help set up my collective's servos to exactly 90 degrees.
1) hold the digital pitch gauge (aka the DPG) up against the side of the servo body.
2) Zero the DPG. Now it is aligned with the servo's body.
3) line up the appropriate edge of the DPG with the centerline of the servo arm. The reading shows you how close you are to a perfect 90.
Here's another trick to help make this work.
a) I stuck the tips of two toothpicks (the round kind) through a couple of well separated holes in the servo arm.
b) Next, I laid the shaft of a long hex driver against the toothpick tips. In this way the hex driver' shaft acted like an 'extension' of the centerline of the servo arm.
c) And I was then able to rest the DPG on on the hex driver's shaft.
Though I must admit, my DPG has a magnet, allowing it to cling to the hex driver shaft, making this much less awkward than it sounds.
Maybe this has been done before?
Maybe some warnings about the total loss of my Heli because I did this?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New Product||Flybarless Digital Pitch Gauge for R/C Helicopter||Daniel.A design||Electric Heli Talk||8||Aug 22, 2013 03:39 AM|
|Sold||RC Logger Digital Pitch Gauge||ohsnap||Aircraft - Electric - Helis (FS/W)||2||Jan 29, 2013 07:44 PM|
|Sold||BNIB Align AP800 Digital Pitch Gauge - $30 Shipped||Warren||Aircraft - Electric - Helis (FS/W)||0||Jan 22, 2013 09:25 PM|
|Sold||RC Logger Digital Pitch Gauge||skeetter||Aircraft - General - Miscellaneous (FS/W)||0||Jan 14, 2013 11:15 AM|
|Sold||NIP Digital angle gauge **used to make a digital pitch gauge**||Blik||Aircraft - General - Miscellaneous (FS/W)||1||Dec 28, 2011 11:20 PM|