|May 30, 2012, 10:19 AM|
Joined May 2012
damaged v4? or what?
I purchased a set of Eagle Tree almost complete (OSD Pro. Altimeter v4. GPS v4. Guardian Stabilization. Elogger v4 heavy duty)
when you connect it turns out that the Guardian does not work, it does not see the program on a PC, you can not upload new firmware, none of the LED is not lit.
OSD Pro none of the LED is not blinking.
Altimeter and osdpro and elogger can upload new software.
The gps still flashing yellow LED.
|Jun 02, 2012, 04:02 PM|
Hi Marcin, sorry for your issue.
The OSD Pro does not have an LED.
If the Guardian's LED is not blinking, that means it is not getting power. is it possible that it is not connected correctly? If you connect only the Guardian to the eLogger (without the OSD pro and without the altimeter) does the Guardian's LED blink? And, does the Guardian show up on the "Firmware Control" page in the PC software at this point?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion What do you do with all the damaged planes you aquire?||xrx1113||Electric Plane Talk||38||May 29, 2013 08:25 PM|
|Help! It helps Xaircraft X 650 V4 or V8? Xaircraft FC1212-P or DJI Naza?||Ruyman||Multirotor Talk||2||May 20, 2012 10:50 PM|
|Discussion Hooked my ESC & battery up backwards, what's damaged?||flyboy320||Power Systems||5||Nov 23, 2011 11:04 PM|
|Yippee! Flying a cx2, lama v3, or v4 outside, what you need?||leethetreeguy||Coaxial Helicopters||2049||Aug 01, 2011 03:26 PM|
|Discussion What to get? Lama v4, KOB, or other?||coby||Coaxial Helicopters||21||Aug 10, 2009 02:28 AM|