|Jan 24, 2013, 10:17 AM|
I have frequently ranted about the importance of securing set-screw types of propeller hubs to motor/gearbox shafts. Well, attached is a picture of a tool that makes it easier.
While it appears to be just another T-handle allen wrench, it has a special hex shape that allows it to deliver higher torque with less risk of stripping the hex on the screw. If you have never stripped the hex on a hex head set screw (especially with a ball end allen wrench) -- especially on a propeller hub -- you just haven't lived. When this happens, removing the damaged screw is nearly impossible without destroying, at the very least, the spinner, and often, much more.
This tool is available at:
While you are at it, you can purchase metric set screws in bulk and low strength Loctite.
|Jan 24, 2013, 12:05 PM|
Good tip Don. The hex drivers sold for model helicopters are also high quality and resist gauling set screws. I use them on all my high(er) torque requiring needs.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||A simple LiPo performance tool||jj604||Batteries and Chargers||767||Jan 13, 2015 12:08 PM|
|Discussion||Anyone familiar with this simple tool||GMB48||The Builders Workshop||17||Dec 25, 2010 02:36 PM|
|Discussion||Simple Dual Boom EPS Pusher Build & How To Make Hot Wire Tools||critterhunter||Foamies (Scratchbuilt)||6||Jun 01, 2009 11:18 AM|
|Nice simple image organization and editing tool for posting images||Vindicator!||Parkflyers||0||Jul 18, 2004 12:26 PM|