|Aug 22, 2014, 02:25 PM|
Water consumption with Battery Minder
Havenít been using my deep cycles much; and keep them connected to my Battery Minder ( http://www.northerntool.com/shop/too...2201_200332201 & http://www.batteryminders.com/batter...er-desulfator/ ) in desulfate mode.
Just checked the water level since last fall Ė at/or below the top of the plates.
I didnít think the Minder would cause that much water comsumption; do others see the same?
Here some thread that might be of interest:
|Aug 23, 2014, 04:59 AM|
Australia, VIC, Melbourne
Joined Feb 2010
AFAIK desulfation is accomplished by overcharging. Overcharging also causes the cells to split water to H2 and O2, thus why your cells are consuming water.
The charger should have a maintenance (float?) mode, this will keep them fully charged, without excessive water losses.
|Aug 23, 2014, 12:09 PM|
Any wet cell battery will need electrolyte levels topped off duriing/after charging even with a smart trickle charger. Fluid loss at low charge rates is less than with higher charge rates.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Closed thread too fast Battery Minders people look here||BVH||Non R/C Items (FS/W)||12||Aug 20, 2013 07:24 PM|
|Discussion||Drive battery consumption monitoring with telemetry||Blue Bird||Radios||9||Aug 21, 2010 12:07 PM|
|Discussion||NiCd battery minder for Tx and Rx||robhinze||Batteries and Chargers||2||Aug 03, 2010 12:38 PM|
|Discussion||Water Consumption ???||Pibber||Dock Talk||2||Jan 31, 2009 01:04 PM|
|Discussion||Battery Minder Plus||E-Challenged||Batteries and Chargers||5||Apr 02, 2008 01:17 PM|