|Dec 02, 2013, 07:11 PM|
Illuminating a Logo Cap With LED?
I'm having the following small cap with an engraved logo 3d printed for me ...
The white would represent solid material and the dark would be empty, if that makes sense. I have not considered adding a clear / translucent film but would do so if that is recommended.
I want to illuminate the cut out logo with blue LED. I want to avoid being able to see the LED and have the light distributed as evenly as possible. I was thinking of placing the LED diode (or diodes?) behind the upper part of the skull so it is hidden. I have up to 12V to power the LEDs and can step down to 5V (but would prefer 12V if possible to avoid using a BEC).
Any advice would be greatly appreciated.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||very nice Cap 232 with low time Saito 91 250.00||HUGH DURDEN||Aircraft - Fuel - Airplanes (FS/W)||1||Dec 07, 2013 08:33 PM|
|Question||EP Buddy Parallel Board-LED light does not illuminate||Buster1000||Batteries and Chargers||15||Jul 04, 2013 05:58 AM|
|Discussion||Timer for LED illumination of the screen||AndrewStick||DIY Electronics||0||May 08, 2011 05:43 AM|
|Question||Camera with IR illumination......||David A Ramsey||DIY Electronics||8||May 01, 2011 02:34 PM|