|Dec 10, 2013, 07:17 PM|
Joined Mar 2011
Fat Shark Attitude SD A/V port problem
I've had my Fat Shark Attitude SD's for a while now, and i'm having a problem with the A/V in and out port on the side of the unit by the power plug. I don't get any signal either in using an external receiver or out with the stock internal receiver unless I put way too much pressure on the supplied 3.5mm cable. I have to wiggle, tilt, jam, tweek really hard to get any signal to show up on an external screen (when using internal RX) and also I get similar picture inside the goggles if I use an external receiver (RMRC 900mhz unit). Once the pressure is released, the signal dies.
I have barely used this A/V port at all, so it should not be worn out.
I've tried coating the 3.5mm plug with solder to give it a little extra diameter to make contact, but it had little affect.
Anyone else have this problem? I may need to send back these googles for repair since I want to start dabbling in 900 mhz stuff...
|Yesterday, 01:29 AM|
Mine was tight the first couple of times I used it as had to push hard to get a jack into the socket fully. But now its loosened up and is OK.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Fat shark Attitude sd in stock Hobbyking||mark the shark||FPV Talk||20||Dec 10, 2013 10:31 AM|
|Sold Fat Shark Attitude SD as new||CEGA||FPV/RPV - Equipment and Vehicles (FS/W)||2||Dec 07, 2013 08:39 PM|
|Sold Fat Shark Attitude SD||HBJ069||FPV/RPV - Equipment and Vehicles (FS/W)||4||Aug 01, 2013 02:02 PM|
|Wanted FAT SHARK Attitude SD Goggles||Jelico||FPV/RPV - Equipment and Vehicles (FS/W)||1||Apr 18, 2013 05:21 AM|
|Found Fat Shark Attitudes SD NIB only||mrfliboy||FPV/RPV - Equipment and Vehicles (FS/W)||0||Apr 09, 2013 09:20 AM|