 |
 |
 |
|
Oct 20, 2003, 07:01 PM
|
|
Seattle, Washington, United States
Joined Mar 2003
1,610 Posts
|
Best rudder servo for Magic 3d
Hey guys,
Asking a question for a friend who flys a modeltech magic 3d with Mega 20/22/2 4s4p TP 6100 He is in need of a faster rudder servo, digital or normal for better control in a hover. I dont fly anything this big so I am not much help Any Suggestions I was maybe thinking of the Hitec digital micro or mino servos Thanks Tabb |
 |
|
|
|
|
Oct 20, 2003, 08:09 PM
|
|
Hayden, ID
Joined Apr 2001
4,400 Posts
|
The Hitec 225's are fine and a little smaller, standard Futaba servos are fast enough to control Magics in a hover with enough precision to hover rock steady. Sounds like he needs faster thumbs.
 --Paul |
|
|
|
|
Oct 20, 2003, 08:18 PM
|
|
Calgary, Alberta
Joined Nov 2001
1,483 Posts
|
A Hitec HS85MG worked fine for me...on four cells even. Try a five cell reciever pack if you need faster response.
|
|
|
|
|
Oct 20, 2003, 11:08 PM
|
|
|
Seattle, Washington, United States
Joined Mar 2003
1,610 Posts
|
I think he is running a UBEC, but thanks for the input guys
Tabb |
|
|
|
|
Oct 20, 2003, 11:36 PM
|
|
USA, NC, Greenville
Joined Dec 1999
9,025 Posts
|
Mine has HS-225's in the tail and 85's in the wing.
|
 |
|
|
Oct 20, 2003, 11:39 PM
|
|
San Jose, California, United States
Joined Feb 2002
2,128 Posts
|
I would use a Futaba 3102. It's small, high torque and accurate. They've also been repriced from $60 to $30 at TowerHobbies. I've used the HS85 and 225. They are both very fast but a bit sloppy towards the center. Also, if you test about 4 225s, you'll find at least one that delays as it moves to center. It causes noticeable problems when you try to level out your plane.
-- Kyle |
|
|
|
|
Oct 21, 2003, 01:51 PM
|
|
|
Seattle, Washington, United States
Joined Mar 2003
1,610 Posts
|
Thanks guys, I will pass this on to him
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What is the Best AXI setup for 15oz 3D? | JohnnyDeluxe | 3D Flying | 77 | Jul 31, 2009 05:15 PM |
| where should I install my rudder servo for SA Groove 480? | lagcisco | 3D Flying | 0 | Apr 15, 2004 08:15 PM |
| Best tail servo for Hornet CP | jiri | Micro Helis | 0 | Nov 23, 2003 05:57 AM |
| Best micro servo for low voltage? | Tapio | Radios | 4 | Aug 28, 2002 07:04 AM |
| Metal gears required for all 4 servos for Magic 3d? | Balin | Sport Planes | 3 | Nov 14, 2001 10:49 AM |
|
|