Espritmodel.com Telemetry Radio
Reply
Thread Tools
Old Jul 29, 2014, 02:42 AM
Registered User
Joined Jul 2014
1 Posts
Discussion
Phantom 2 Board in P1 (FC40) shell?

Hi All,

I was wondering if it was possible to fit a Phantom 2 board into a Phantom 1 (or FC40) shell? Main objective to get a canbus port without soldering microsurgery which I am not confident with. I was planning on fittingan iOSD mini and FPV tx. I have seen posts that have refer to this as an option for Phantom 1.5 project which I was going to jump into however I have recently also ready about success with fitting Walkera 5200 lipos or HK Multistar 4000s to the P1 Shell.

As a side issue I was curious whether on board gimbal controller might drive units other than Zemuse? Like a Walkera G-2D which I already have and works fine. (Just looking to save weight as when I fitted the Gimbal & GoPro the flight time halved instantly.

Regards


http://www.rcgroups.com/forums/showa...7&d=1406618863
Route66 is offline Find More Posts by Route66
Reply With Quote
Sign up now
to remove ads between posts
Old Jul 29, 2014, 07:17 AM
Registered User
Joined Apr 2011
25 Posts
Naza on P2 is simple Naza v2. Isnt special about Smart Battery. But P2 mainboard special for P2 Smart Battery. I think getting separate PMU v2 for iOSD is much more simple. Or use MinosdNaza.
SchumiRC is offline Find More Posts by SchumiRC
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion DJI Phantom Vision 2 shell replacement stuck ig720 DJI-Innovations 11 Jun 29, 2014 06:09 PM
Sold DJi Phantom 2 shell CyberVet65 Aircraft - Electric - Multirotor (FS/W) 3 May 01, 2014 01:50 PM
Sold Ready to Fly ArduPhantom - APM 2.6 (+ GPS / Compass) in DJI Phantom Shell itsbiscuits Aircraft - Electric - Multirotor (FS/W) 1 Apr 03, 2014 02:00 PM
Sold Ready to Fly ArduPhantom - APM 2.6 (+ GPS / Compass) in DJI Phantom Shell itsbiscuits FPV Equipment (FS/W) 1 Apr 03, 2014 01:59 PM