Replacement duct exhaust
The repaired F16 I have ... when given the rear duct piece - noted it was angled ..
The angle matched the fuselage and so I fitted it. But I'm having concerns about the internal duct angles ...
The Duct aligns with the fuselage nicely BUT if I place a straight edge into the duct I get :
Placed along inside bottom of this tail pipe - the edge has an angle of about 5 degrees up from horizontal ... basically indicating that thrust line will push tail DOWN.
If I place straight edge along inside top of this tail pipe - the edge lies in line with fuselage ... indicating a straight thrust line ...
I'm looking for opinions / views on whether I should cut and angle the tail pipe slightly to obtain an averaged thrust line straight with fuselage ?
The model is the Lanxui 70mm F16.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Need replacement exhaust cone for Magnum Pro 45!||richman03||Engines||7||Jul 26, 2012 03:03 PM|
|Wattage PDF 400 exhaust duct diameter||P_J_Glor||Electric Ducted Fan Jet Talk||6||Dec 24, 2003 05:14 PM|
|Question||Taper exhaust ducting to FSA??||meteor||Electric Ducted Fan Jet Talk||1||Oct 15, 2003 10:58 PM|
|Drastically oval Exhaust Ducting||wtghost||Electric Ducted Fan Jet Talk||2||Jun 12, 2003 11:13 PM|
|Ducted fan restricted exhaust||Mikey_Flies||Power Systems||7||Jul 16, 2001 04:38 AM|