Extra 3D Adrenalin and some Q's
I ordered the plane from NESail with the Rotex package. Doesn't say what prop it comes with but I do have a question about the props.
According to this chart:
Motor Prop (GWS) Battery Amps Thrust (gms)
Rotex 25/6/15 10 x 4.7 2-cell Li-Poly 5 270
Rotex 25/6/15 11 x 4.7 2-cell Li-Poly 6 310
Rotex 25/6/15 9 x 5 3-cell Li-Poly 7.5 440
Rotex 25/6/15 10 x 4.7 3-cell Li-Poly 10.2 500
Rotex 25/6/15 11 x 4.7 3-cell Li-Poly 10.5 550
If I were to use the 10x4.7 GWS props which pulls out 10.2 amps of current load with the 10 amp esc it comes with, would it fry the esc???
reason I ask is because I have a few 10x4.7 props that can be used. I want to put them into good use and not just let it sit there..
Boy I can't wait for some brushless action.
Oh one more thing. it comes with the 700mAh 3 cell lipo. Could I go with 800s or even 1200s??
I would like to use 2 cells instead of three. If using 2 cell is possible for this motor setup, how much mAh would be needed to draw enough power for the motor? I was thinking like a 2 cell thunder power 2100 or something similar without drawing over 10 amps
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|FS: Free Air Extra 3D adrenalin||tomi||Aircraft - Electric - Airplanes (FS/W)||1||May 22, 2004 05:24 PM|
|FS: RTF Extra 3D Adrenalin - minus RX||tomi||Aircraft - Electric - Airplanes (FS/W)||1||Apr 24, 2004 11:26 PM|
|Extra 3D servos ( 4.9's Discontinued? )||rickc||3D Flying||2||Apr 03, 2004 04:36 PM|
|eclipse spectra users- some q's||DesignGeek||Electric Plane Talk||9||Aug 25, 2002 10:14 PM|
|got some q's about my t-52||logan5||Foamies (Kits)||2||May 09, 2001 10:00 PM|