|Jan 11, 2010, 12:47 AM|
My Big Lama Tailboom Conversion
After damaging my stock canopy, I knew that I needed to make a tailboom for my Brushless Big lama, (BLBL). I have been sitting on a donor, a skyartec wasp that I can't fix and gave up on. The guts will go to my cybird P2 ornithopter but the tailboom has gone to my BLBL. After removing all of the guts off of the wasp frame, I began thinking about how to do this. The best part about it all is that I didn't have to spend anymore money because I recycled my pars, YES!!!!!!!!!!!
I didn't put any lights back on it, I may not bother. I don't fly much outdoors in the winter and come the summer over here, it's light until 12:15am
Here are some pictures that show how I did it, I think its easier to look than to try to explain but here goes:
I used an angle grinder to cut some of the frame from the wasp. I attached it to the bottom, (where the lipo goes but without blocking access). I used some strips of metal that I salvaged from my old wiper blades, (I knew they'd come in handy), drilling holes in them was hard. I reused the rear prop from the BLBL and combined it with the rear vertical fin from the wasp; the prop spins freely.
The canopy is from the wasp and needs to be cleaned and painted. It's covered with sticky residue that I need to scrub off. I'd really like to get a bigger canopy on this beast.
I did a test flight in the house and all is great. Bottom blades are a little out of tracking but nothing major.
I can't wait to get this bird outside!!
As for pics, The BLBL is the one with the white canopy. I also included my CX3 with the red CX2 canopy just for a size comparison There is also a picture if the BLBL with the red CX2 canopy in it just for fun. The other pics are just some build shots. I hope it pretty much shows how I attached it, it was simply a macGyver sort of job but hey.....it worked!!
ImagesView all Images in thread
|Jan 11, 2010, 10:35 AM|
A lot of engineering and thought went into that, NICE JOB!
For some reason I get the feeling it is tail heavy because that frame going so far back but yet the overall proportions look right.
|Jan 11, 2010, 09:30 PM|
Thanks all, I've been thinking about it all day at work.
Once I stripped the wasp frame and tailboom, I couldn't believe how light it was, ( I should have weighd it).
Durk, I do have some room to shorten it if I need to, I can slide the boom in more or I can slide the tail fin in more without ruining the over all look.
I want a 450 size canopy on too!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Big Lama Questions||mjosparky||Coaxial Helicopters||12||Feb 03, 2014 12:03 PM|
|Discussion||AEO Brushless conversion for LAMA 2||nycheli||Coaxial Helicopters||21||Jul 08, 2010 12:05 AM|
|Discussion||big lama vs. 53 #8||chidago||Coaxial Helicopters||3||Dec 12, 2009 01:09 AM|
|Discussion||.40 size extra conversion...my first big conversion.||papasmurf||Sport Planes||24||Oct 15, 2006 08:46 AM|