|Dec 28, 2012, 03:35 AM|
Australia, VIC, Croydon
Joined Dec 2012
i have a hobbyking 20a esc.
When i connect it up servo control works fine but when i apply throttle the the motor moves about one centimeter in one direction before moving the other direction also about a centimeter the motor (brushless) makes a loud sound when it has to change direction.
When i apply more throttle it just moves back and forth more quickly and loudly.
It is not the motor as i tested my setup with a different esc and it worked fine.
Im just asking on the off chance that it is not broken.
|Dec 28, 2012, 03:55 AM|
There's a bad connection in one of the three leads between the motor and ESC. Go over all the solder joints and connections and make sure everything has solid electrical and mechanical contact.
Do not try to force the motor to run in this condition. You'll burn out the ESC. If the motor doesn't immediately start up and run smoothly, cut the throttle and fix the problem before trying again.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||esc problem||shadi89||Electric Motor Design and Construction||5||Mar 23, 2012 02:53 PM|
|Discussion||Motor/ESC Problem||theduke44||Electric Heli Talk||6||Mar 02, 2012 02:38 AM|
|Help!||Car not braking - ESC problem?||fatbaldboy||Off-road Cars||9||Mar 01, 2012 05:14 PM|
|Discussion||battery or ESC problem?||Joe Casey||Batteries and Chargers||12||Feb 28, 2012 05:43 PM|
|Discussion||Motor or ESC problem?||flyinsolo11||Power Systems||6||Feb 24, 2012 07:54 AM|