|Feb 08, 2012, 05:41 PM|
Pittsburgh, PA USA
Joined Apr 2001
Recommended Timing for a Copterx 430XL Motor
I have this motor in a CX450 SE V2 Helicopter with a Phoenix 35 ESC.
CopterX (CX450-10-04) 430XL Brushless Motor (3550KV)
I see on another Forum that CopterX recommend 7° for 6-8 poles timing.
Someone opened one and reports:
opened it up and counted manually. 12n8p motor, 12 nuts on the stator, 8 magnets.
My problem is that sometimes at lift off I start to get surges / pulses of power and have to throttle back down and restart.
During flight, on my 3rd or 4th pack (in winter though so air temp is only around 40 F) I sometimes get a sudden noticeable increase in speed for 30 sec or so then it drops back to the original power level.
I just am learning so only fly lazy 8s and circuits.
I suppose it must be a problem with the motor, wiring or an ESC - motor mismatch. The wiring all looks OK. I have a new motor on order. However, if it were just settings, I would be able to fly now.
Motor start power = Low (39)
Motor Timing = Normal (5) (Default)
Direction = Reverse
PWM Rate = 12 kHz (Default) [The motor ran with 4 "Outrunner" mode, but very badly.]
Phoenix firmware = V3.28
Do you have any recommendations ?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||BNIB align 430xl brushless motor||wrxtacy2003||Aircraft - Electric - Power Systems (FS/W)||6||Jan 10, 2013 03:39 PM|
|Sold||430XL brushless motor||pttse||Aircraft - Electric - Power Systems (FS/W)||0||Nov 19, 2011 12:04 AM|
|Discussion||copterx 450 50 amp esc and 430xl motor||gewiens||Mini Helis||20||Oct 17, 2011 01:07 PM|
|Discussion||What is the recommended DD tail motor for 450 multiblade heli?||control flyer||Beginner Training Area (Heli-Electric)||2||Sep 08, 2011 06:47 PM|
|Question||Recommended plane for 10g Brushless motor???||Lilbanks96||Scratchbuilt Indoor and Micro Models||12||Jun 30, 2011 06:41 AM|