|Oct 08, 2011, 03:44 AM|
Replacement Servo for my W852 (Walkerized HQ852) 40cm coax heli.
Just noting here that I used the same servo that's used in the Esky lama v4 fine to replace the busted aileron servo (starboard side), EXCEPT:
- The servo direction was opposite from the stock so reversing the directiom on tje tx was needed.
- The mounting holes on the esky servo needed to be widened by drilling to 2.5-3.0mm so that it would fit the mount just right.
After changing the servo one of the motors failed... Not related. It was about time anyway. Another time...
edit: I actually replaced the front motor that day in 20 mins. Back to flying
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Looking for replacement blades for HCW 8501 (36 inch 3ch heli)||caall99||Coaxial Helicopters||1||Oct 01, 2011 08:53 PM|
|Question||Anything better than Brookstone coax heli?||nuggetz||Coaxial Helicopters||7||Sep 08, 2011 03:11 AM|
|Discussion||Small metal coax heli for $19.99, today only. Link inside...||Heli_Noob||Coaxial Helicopters||6||Aug 20, 2011 09:22 AM|
|Found||big coax heli for dl rx||ROCKY2||FPV Equipment (FS/W)||0||May 23, 2011 12:04 PM|
|Help!||coax heli vs blade mSR W/ parts support for first heli||lwilton651||Beginner Training Area (Heli-Electric)||22||Feb 15, 2011 02:27 AM|