|Oct 09, 2012, 03:40 PM|
New Stuff lam film
I've used this on my Slope Monkey wing. It stick great to balsa, but not so much on EPP. There are lots of air pockets where it didn't bond. I was working from the middle outwards FWIW.
The instructions I first read were to keep the temp at 220°, but I found this didn't melt the adhesive backing adequately. 300° worked better.
Could it possibly too hot and affect the EPP itself preventing a good bond?
I thought I read once somebody used 3M77 on the EPP first and then applied the New Stuff...but can't find where I read it. Would this be a realistic technique?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question maximizing Lam film application||grfcon||Dynamic Soaring||5||May 01, 2012 06:44 PM|
|Help! look for about 11 feet of 10 mil lam film in L.A.||grfcon||Slope||1||Mar 15, 2012 03:20 PM|
|Wanted anybody got any 10 mil lam film in L.A. I could buy?||grfcon||Aircraft - Electric - Airplanes (FS/W)||0||Mar 15, 2012 12:01 PM|
|Wanted anybody got any 10 mil lam film in L.A. I could buy?||grfcon||Aircraft - Electric - Airplanes (FS/W)||0||Mar 15, 2012 12:00 PM|
|Help! anybody got any 10 mil lam film in L.A. I could buy?||grfcon||Dynamic Soaring||0||Mar 15, 2012 11:57 AM|